The RDB-325 pipe bender has a massive capacity of 2″ Schedule 80 pipe (Mild Steel T.S. 64,000 PSI) and 3″ round tubing with a 16″ maximum center lines depending on material OD. Tooling for the RDB-325 is the same high quality tooling that entire line of Baileigh Industrial top loading tube benders use and with over 5000 die sets available, there will be one for your application.
This pipe bender comes standard with a simple to use touch-screen controller that holds up to 170 programs with up to ten bends per program. If more memory is needed, a memory card (standard 2CB SD card, max) can be used to store programs as well.
|Mild Steel Pipe (Schedule 40)||2.00″ — 60mm x 5.5mm|
|Aluminum Pipe (Schedule 40)||2.50″ — 73mm x 5.5mm|
|Stainless Steel Pipe (Schedule 40)||2.00″ — 60mm x 4mm|
|Mild Steel Round Tube (Wall)||3.00″ (.095) — 76mm x 2.5mm|
|Aluminum Round Tube (Wall)||3.00″ (.203) — 76mm x 5mm|
|Stainless Steel Round Tube (Wall)||3.00″ (.095) — 76mm x 2.5mm|
|Chromolly Round Tube (Wall)||3.00″ (.083) — 76mm x 2mm|
|Mild Steel Rod||1.25″ (32mm)|
|Mild Steel Square Tube (Wall)||2.00″ (.125) — 50mm x 3mm|
|Minimum OD||.25″ — 6mm|
|Maximum Speed to 180 Degrees||10 Sec.|
|Maximum Center Line Radius (CLR)*||16.50″ (419mm)|
|Minimum CLR||.50″ (13mm)|
|Power Requirements||220V (1Ph)– 400V, 3Ph, 50Hz|
|Weight (lbs.)||1200 (545 kg.)|
Video of the Baileigh Programmable Tube Bender RDB-325:
Options for Baileigh Industrial Tube Benders:
Baileigh Rotary Positioning Table – IDX-10
What is the perfect complement to any computer controlled Baileigh Tube and Pipe Bender? A Rotary Positioning Table, of course.
A Baileigh Industrial tube bender fitted with a rotary positioning table allows for accurate bends in varying planes, as well as consistent measurements between bends. Available for the RDB-250, 325, and 350-TS, the tables are available in lengths of 5, 10, 15, and 20′, there is a table perfect for any size shop. Only have some jobs that would require the rotary indexing table, it can be attached or taken off of the bender with ease.
The table comes with an 8″ three jaw chuck with 2-1/2″ thru hole that allows for longer pieces of tubing than the table length. Chuck can handle up to 4-1/2″ OD. The minimum OD is 1/4″. The table has a linear indicator strip so the operator can set up accurate distances between bends. Mechanical stops can be positioned for the start of each bend. Using the mechanical stops is very beneficial for repeatability on bigger production runs. Another nice feature of the table is that the positioning carriage rolls on a precision V block rail and rides the rail using V-block bearings. These bearings are placed on eccentric shafts, which allows for tolerance adjustment allowing the most accurate results.
Please call for more information on Baileigh Programmable Tube Bender RDB-325 1 (800) 286-3624