The RDB-350-TS pipe bender has the capacity to bend 2.5″ schedule 40 pipe and up to 3″ tube with a .187″ wall thickness. As with all Baileigh Industrial tube benders, the RDB-350-TS accepts Baileigh Industrial’s standard drop on tooling.
This pipe bender comes standard with a simple to use touch-screen controller that holds up to 170 programs with up to ten bends per program. If more memory is needed, a memory card (standard 2CB SD card, max) can be used to store programs as well.
|Mild Steel Pipe (Schedule 40)||2.50″ — 73mm x 5mm|
|Aluminum Pipe (Schedule 40)||3.00″ — 89mm x 5mm|
|Stainless Steel Pipe (Schedule 40)||2.00″ — 60mm x 4mm|
|Mild Steel Round Tube (Wall)||3.00″ (.187) — 76mm x 5mm|
|Aluminum Round Tube (Wall)||3.50″ (.250) — 89mm x 6.5mm|
|Stainless Steel Round Tube (Wall)||3.00″ (.125) — 76mm x 3mm|
|Chromolly Round Tube (Wall)||2.50″ (.125) — 64mm x 3mm|
|Mild Steel Rod||1.50″ (38mm)|
|Mild Steel Square Tube (Wall)||3.00″ (.125) — 76mm x 3mm|
|Minimum OD||.24″ — 6mm|
|Maximum Speed to 180 Degrees||16 Sec.|
|Maximum Center Line Radius (CLR)*||24.00″ (610mm)|
|Minimum CLR||.50″ (13mm)|
|Power Requirements||220V (3Ph)– 400V, 3Ph, 50Hz|
|Weight (lbs.)||1500 (681 kg.)|
Video of the Baileigh Programmable Tube Bender RDB-350-TS:
Baileigh Rotary Positioning Table – IDX-10
What is the perfect complement to any computer controlled Baileigh Tube and Pipe Bender? A Rotary Positioning Table, of course.
A Baileigh Industrial tube bender fitted with a rotary positioning table allows for accurate bends in varying planes, as well as consistent measurements between bends. Available for the RDB-250, 325, and 350-TS, the tables are available in lengths of 5, 10, 15, and 20′, there is a table perfect for any size shop. Only have some jobs that would require the rotary indexing table, it can be attached or taken off of the bender with ease.
The table comes with an 8″ three jaw chuck with 2-1/2″ thru hole that allows for longer pieces of tubing than the table length. Chuck can handle up to 4-1/2″ OD. The minimum OD is 1/4″. The table has a linear indicator strip so the operator can set up accurate distances between bends. Mechanical stops can be positioned for the start of each bend. Using the mechanical stops is very beneficial for repeatability on bigger production runs. Another nice feature of the table is that the positioning carriage rolls on a precision V block rail and rides the rail using V-block bearings. These bearings are placed on eccentric shafts, which allows for tolerance adjustment allowing the most accurate results.
Please call for more information on Baileigh Programmable Tube Bender RDB-350-TS 1 (800) 286-3624